Hydrapak Inline Connector

• Hydration upgrade: Adds a useful quick-disconnect point to a compatible hydration system that does not already have one.
• Quick disconnect: Creates an easily accessible disconnect point within the drinking tube.
• Push-button release: Separates the two sections of hose at the push of a button.
• Leave the hose in position: Allows the reservoir and its section of tube to be removed while the remaining drinking hose stays routed through the pack.
• Easier refilling and cleaning: Reduces the need to remove and reroute the complete drinking tube each time the reservoir is taken out.
• Retrofit design: Can be added to a compatible existing hydration system by cutting the drinking tube and fitting the connector inline.
• Filter use: Provides an inline connection point that can also be useful when integrating compatible water filtration equipment.

The Inline Connector is installed within the drinking tube rather than directly into the reservoir.

Choose the required disconnect position, cut the compatible hydration tube and attach one Inline Connector component to each cut end.

Check the diameter and compatibility of your drinking tube before cutting or installing the connector.

For advice on hydration reservoirs, tubes, valves, quick disconnects and replacement components, see our Running Hydration Bladders & Reservoirs Guide.

If you are unsure whether the Inline Connector is compatible with your hydration system, get in touch for straightforward advice.